HP Step-by-steppatch uninstallation

To do…	Use the command…	Remarks
		Required
		• After you activate a patch, the
		patch takes effect and is in the
		test-run stage. After the switch is
	patch active patch-numberslot	reset or rebooted, the patch
Activate the specified patches		becomes invalid.
	slot-number	• If you find that an ACTIVE patch
		is of some problem, reboot the
		switch to deactivate the patch,
		so as to avoid a series of
		running faults resulting from
		patch error.
		Required
		After you confirm the running of a
Confirm the running of the	patch run patch-number[ slot	patch, the patch state becomes
		RUNNING, and the patch is in the
specified patches	slot-number ]
		normal running stage. After the
		switch is reset or rebooted, the
		patch is still valid.

NOTE:

•Set the file transfer mode to binary mode before using FTP or TFTP to upload/download patch files to/from the Flash of the switch. Otherwise, patch file cannot be parsed properly.

•This operation is applicable to patches in the ACTIVE state only.

Step-by-step patch uninstallation

Follow these steps to stop running patches:

To do…	Use the command…	Remarks
Enter system view	system-view	—
		Required
	patch deactive patch-numberslot	When you stop running a patch,
Stop running the specified patches		the patch state becomes
	slot-number	DEACTIVE, and the system runs in
		the way before it is installed with
		the patch.
		Required
		Deleting patches only removes the
		patches from the memory patch
Delete the specified patches from	patch delete patch-numberslot	area, and does not delete them
		from the storage medium. The
the memory patch area	slot-number	patches turn to the IDLE state after
		this operation. After a patch is
		deleted, the system runs in the way
		it did before the patch was
		installed.

122