HP NMS login example

To do… Use the command… Remarks

snmp-agent usm-user v3 user-namegroup-name[ [ cipher ]

Add a user to the SNMP group authentication-mode { md5 sha } auth-password[ privacy-mode

{3des aes128 des56 }

priv-password ] ] [ acl acl-number ]

Required

If the cipher keyword is specified, both auth-passwordand priv-passwordare cipher text passwords.

Follow these steps to configure SNMPv1 and SNMPv2c settings:

To do…			Use the command…	Remarks
Enter system view			system-view	—
				Optional
				Disabled by default.
Enable SNMP agent			snmp-agent	You can enable SNMP agent
				with this command or any
				command that begins with
				snmp-agent.
			snmp-agent mib-view	Optional
Create or update MIB view information			{ excluded included }	By default, the MIB view
			view-name oid-tree [ mask	name is ViewDefault and
			mask-value ]	OID is 1.
			snmp-agent community
		Configure an	{ read write }	Required
	Directly	SNMP	community-name [ acl
				Use either approach.
		community	acl-number mib-view
			view-name ]*	The direction configuration
Configure			snmp-agent group { v1	approach is for SNMPv1 or
				SNMPv2c. The community
			v2c } group-name
SNMP NMS		Configure an		name configured on the
			[ read-view read-view]
access right				NMS should be consistent
		SNMP group	[ write-view write-view]
				with the username configured
	Indirectly		[ notify-view notify-view]
				on the agent.
			[ acl acl-number ]
				The indirect configuration
			snmp-agent usm-user { v1
		Add a user to the		approach is for SNMPv3.
			v2c } user-name group-name
		SNMP group
			[ acl acl-number ]

NOTE:

The device supports the following SNMP versions: SNMPv1, SNMPv2c and SNMPv3. For more information about SNMP, see the Network Management and Monitoring Configuration Guide.

NMS login example

In this example, iMC is used as the NMS.

1.Configuration on the device

#Assign IP address of device. Make sure the device and the NMS can reach each other. (Configuration steps are omitted.)

75