HP Configuring the SSH client to log in to the SSH server

•Reference the created HWTACACS scheme in the ISP domain. For more information, see the Security Configuration Guide.

When users adopt the scheme mode to log in to the device, the level of the commands that the users can access depends on the user privilege level defined in the AAA scheme.

•When the AAA scheme is local, the user privilege level is defined by the authorization-attribute level level command.

•When the AAA scheme is RADIUS or HWTACACS, the user privilege level is configured on the RADIUS or HWTACACS server.

•For more information about AAA, RADIUS, and HWTACACS, see the Security Configuration Guide.

Configuring the SSH client to log in to the SSH server

Configuration prerequisites

You have logged in to the device.

By default, you can log in to the device through the console port without authentication and have user privilege level 3 after login. For information about logging in to the device with the default configuration, see “Configuration requirements.”

Figure 18 Log in to another device from the current device

NOTE:

If the SSH client and the SSH server are not in the same subnet, make sure that the two devices can reach each other.

Configuration procedure

Follow these steps to configure the SSH client to log in to the SSH server:

To do…	Use the command…	Remarks
		Required
Log in to an IPv4 SSH server	ssh2 server	server is the IPv4 address or host
		name of the server.
		Available in user view
		Required
Log in to an IPv6 SSH server	ssh2 ipv6 server	server is the IPv6 address or host
		name of the server.
		Available in user view

NOTE:

You can configure other settings for the SSH client to work with the SSH server. For more information, see the Security Configuration Guide.

51