HP Modifying the level of a command

User interface	User privilege level	Information input for the	Information input after the
	switch
authentication
	authentication	first authentication mode	authentication mode changes
mode
	mode
	local	Local user privilege level	—
		switch password
			Password for privilege level
		Local user privilege level	switch (configured on the AAA
	local scheme		server). The system uses the
		switch password	username used for logging in as
			the privilege level switch
			username.
		Password for privilege level
scheme		switch (configured on the
	scheme	AAA server). The system uses	—
		the username used for
		logging in as the privilege
		level switch username.
		Password for privilege level
		switch (configured on the
	scheme local	AAA server). The system uses	Local user privilege level switch
		the username used for	password
		logging in as the privilege
		level switch username.

CAUTION:

•When the authentication mode is set to local, configure the local password before switching to a higher user privilege level.

•When the authentication mode is set to scheme, configure AAA related parameters before switching to a higher user privilege level.

•The privilege level switch fails after three consecutive unsuccessful password attempts.

•For more information about user interface authentication, see the chapter “Logging in to the switch configuration.”

Modifying the level of a command

All the commands in a view default to different levels. The administrator can change the default level of a command to a different level as needed.

Follow these steps to modify the command level:

To do…	Use the command…	Remarks
Enter system view	system-view	—
Configure the command level in a	command-privilege level level view	Required
specified view	view command	See Table 5 for the default settings.

19