Using indices If a CD has indices, you may use them to begin play in the middle of a track.
1.Press index mode. (If there was no CD in play, the display will show INDEX SEARCH.) After a brief delay while the transport searches the disc, the LED above the button will flash to indicate index mode.
2.Using next and previous (or the numbered buttons on the Remote Control), select an index.
3.Press play to begin play at the index you selected.
Beginning play at a You may use prg/time on the Remote Control to begin play at a specific time— specific location in a track whether or not it corresponds to an index.
1.Using track + or track
2.Press prg/time, then press the numbered buttons corresponding to when you’d like play to begin. (The numbers you select will ap- pear in the time part of the display.)
3.To begin play at that point, press play.
Note: The time you select depends on the selection you’ve made
with the display mode button: elapsed or remaining, CD or track.
For example, if you want to begin play one minute and thirty seconds into track 2, first press display mode until the elapsed time and on track LEDs light. Then select track 2 by pressing track + or track – (or by entering 02). Press prg/time, enter 130, then press play.
The pause function To suspend play while a CD is playing, press pause. To resume play at the same point, press pause again.
If left in pause for several minutes, the transport will stop spinning and the laser will turn off (thereby enhancing the longevity of both). This will be indicated by the pause indicator in the display (“”) flashing on and off. Alternatively, this extended pause feature may be engaged by pressing and holding the pause button until the indicator begins to flash in the display. Pressing pause again will resume play at the point where pause was first pressed, (after a short delay to allow the disc to get up to speed).
To “cue up” the beginning of a CD or track, press pause before pressing play (5). To begin play, press pause again. (You may also select another track or index while play is suspended.)
Repeating an entire CD To repeat (continuously) all tracks on a CD, press repeat disc. While the repeat disc function is active, the LED above the button is lit. To return to normal play, press repeat disc again.
Repeating a track To repeat (continuously) the track in play, press repeat track. While the repeat track function is active, the LED above the button is lit. To return to normal play, press repeat track again.
39