Unpacking and Placement
Unpacking the Nº31.5 Unpack your Nº31.5 Reference CD Transport and remove all accessories from the carton. Included with your new Mark Levinson transport is a pair of knit, white gloves designed to assist you in the initial unpacking and placement of your new purchase. Please accept them as a token of our appreciation for having purchased one of our products.
Important! | Keep all packing materials for future transport of your Nº31.5. | ||
| Shipping your new component in anything other than its | ||
| |||
| that is not covered by the warranty. | ||
|
|
|
|
Remove the Transport Screws Protecting the finish by placing it on a soft cloth, prop up the Nº31.5 Reference | |||
| CD Transport on its side to provide ready access to the bottom of the center sec- | ||
| tion. Remove the transport screws from the bottom of the unit, along with the | ||
| shipping strap that holds the lid closed during transport. (Note that it is nor- | ||
| mal for the Nº31.5 lid to “float” open before power is supplied to the | ||
| unit.) Save them with all the other packing materials for future use. | ||
|
|
|
|
|
|
|
|
Remove these
screws and washers
Shipping Strap (holds lid closed,
protects finish)
Warning! | The transport screws and shipping strap must be removed |
| before operating the Nº31.5, since they immobilize the |
| transport mechanism and lid during shipping to prevent |
| damage. This strap and these screws must also be replaced |
| before shipping the unit. |
|
|
Placement of the Nº31.5 The Nº31.5 should be placed as close as possible to your digital audio processor, | |
| thus keeping digital interconnect cabling reasonably short. It should be placed on |
| a shelf where it is convenient to operate and receives good ventilation. |
| Be sure to allow 7 inches (18 cm) of clearance above the Nº31.5 to ensure proper |
| operation of the lid assembly. The Nº31.5 must also be within 3° of level from |
| front to back for optimal operation of the lid. (This translates to having the front |
| and back edges of the Nº31.5 within about 1⁄2" or 1.2 cm of level with each other.) |
| Drawings are included in this manual to facilitate special installations and custom |
| cabinetry (see Dimensions). |
6