Removal and Replacement Procedures

8.Flex the right side of the base enclosure near the audio jacks 1 until the jacks clear the base enclosure.

9.Lift the rear edge of the system board and swing it up 2 until the board rests at a 45-degree angle.

10.Slide the system board away from the base enclosure at an angle 3.

Removing the System Board

Reverse the above procedure to install the system board.

Maintenance and Service Guide

5–45

Page 128
Image 128
HP NX9040, NX9030, NX9020, ZE4900 manual Reverse the above procedure to install the system board