loading media
10If the media you are loading is of the same width as the current media, skip the next step and go on to step 12.
11If you are loading media that is of a
different width from the current media, you may need to adjust print quality as follows:
note
The printer is aligned at the factory with 4±mil±thick label stock, whose width is the maximum width accepted by the printer.
a.Raise the hinge plate, and lower the printhead by rotating the printhead latch clockwise to the latched position.
b.Press ON LINE/PAUSE to enable printing.
c.Send a sample test print file from the host, or run the internal diagnostic test file.
note
It may be necessary to feed several labels before proper alignment of the media occurs.
d.If the print quality is acceptable, go on to step 12.
e.Otherwise, press ON LINE/PAUSE again to place the printer in the off line mode.
note
Although the head leveling knob can be adjusted during printing, it is recommended that this adjustment be done while the printer is paused.
Printhead | Media | Hinge |
Latch | Guide | Plate |
Operator's Guide | 9 |
