loading media
13To use the media rewind hub, complete the following procedure.
a.Lower the lower
b.Remove the arc plate from its stored position, and install on the front of
the printer.
Route the media around the arc plate and to the media rewinder.
c. Place the clasp over the end of the media, and rotate the media rewinder a few turns.
Rotate the media guide up, and slide it to the media edge.
d.Lift and snap the lower
Continue with step 14.
14Raise the hinge plate, and lower the printhead by rotating the printhead latch clockwise to the latched position.
15Close the media supply door.
16Press ON LINE/PAUSE to enable printing.
note
It may be necessary to feed several labels before proper alignment of the media occurs.
Operator's Guide | 11 |
