Powering On the Printer
aution
Before powering on the printer, make sure it is plugged into the appropriate power source.
Refer to the ªSelect a Siteº section in Chapter 2 of the Setup Guide for information on proper power sources.
The power switch is located on the lower right±hand corner of the rear of the printer. It is marked f for power OFF and for power ON.
For help with diagnosing printer problems, printer self±test routines are automatically run during the power±on cycle. Further diagnostic tests can be performed using the secondary operator panel functions. They are covered in detail in the Setup Guide.
Using the Primary Operator Panel
AC Power
Switch
AC Power Connector
Fuse
Holder
Use the primary operator panel to perform routine operations. The panel contains three
not
The functions and meanings of some of the keys and indicators on the primary operator panel will change depending on the firmware installed. This manual describes printer operation with Printronix LP+, IGP/PGL or IGP/VGL emulation firmware installed. If your printer has Printronix IGP/FGL emulation firmware, please refer to the T3306 and T3308 Label Printers Operator's Guide, p/n 136452±001.
There is also a secondary operator panel, consisting of a message display and six keys. This panel is used to configure the printer and to run self±tests, via the configuration menus.
Message
Display
Primary
Control
Panel
Message
Display
Contrast
Adjust
Secondary
Control
Panel
Operator's Guide | 1 |
