
loading media
g.Route the media liner (backing) around the tear bar to the media rewinder.
h.Place the clasp over the end of the media, and rotate the media rewinder a few turns.
. Rotate the media guide up, and slide it to the media's edge.
j.Lift and snap the lower right front panel closed.
k.Raise the hinge plate, and latch the printhead by rotating the printhead latch clockwise to the latched position.
l.Close the side cover.
note
It is possible to use the present sensor only (without inverting the tear bar) to provide
Operator's Guide | 13 |