Removing the Ribbon
Generally, ribbons are used to completion and then replaced. Removal of the old ribbon is simply a matter of pulling it off the take±up hub and discarding it.
However, there may be times when the use of direct thermal media is required and an installed ribbon has not been completely used up. (As noted previously, when printing in direct thermal mode, the printer does not use a ribbon.)
In this case, use the following procedure to remove the ribbon.
not
The direct thermal mode is selected through the printer menu system. The main menu is accessed via the secondary operator panel. Refer to the ªConfiguring the Printerº chapter in the Setup Guide for complete instructions in how to access and use the secondary operator panel.
1Press ON LINE/PAUSE to place the printer in the off line mode.
2Open the media supply door.
20
Media
Supply
Window
Media
Supply Door
Operator's Guide
