removing the ribbon
6Slide the used ribbon off the hub, and dispose of it.
7Turn the ribbon supply hub clockwise to draw the unused portion of the ribbon back onto the supply roll.
note
You may leave the unused portion of the ribbon in place until the next thermal transfer print job, at which time you may reinstall it by following the ribbon installation procedure.
8Raise the hinge plate, and lock the printhead by rotating the printhead latch clockwise.
9Close the media supply door.
10Press ON LINE/PAUSE to enable printing.
Printhead | Hinge |
Latch | Plate |
22 | Operator's Guide |
