Unloading Media
Use the following procedure to unload media from the printer.
1Press ON LINE/PAUSE to place the
printer in the off line mode.
Open the media supply door.
2Rotate the printhead latch counterclockwise to unlatch, and raise the printhead to an upright position.
3Lower the hinge plate down. Slide the media guide to the outer edge, and
rotate it to the down position.
4Cut the media either before or after the front slot, depending on whether or not the rewind hub is being used.
noe
If the media rewind hub was being used, you may choose to continue winding the media onto the hub or to roll it back onto the supply roll (media hub).
5If the installed media is fan±folded, skip the next step and go on to step 7.
Otherwise, continue with step 6.
14
Media
Supply
Window
Media
Supply Door
Printhead | Media | Hinge |
Latch | Guide | Plate |
Operator's Guide