setting up and using your workstation

removing and replacing the cover and front bezel

Figure 1-6

HP Workstation x1100 System Board

Memory module sockets supporting two DDR modules

Processor connector (heatsink and processor not shown)

Primary IDE

Connector

AGP Card Slot

Secondary IDE

Connector

Three PCI Card

Floppy Disk Drive

Slots

Connector

 

WARNING

removing and replacing the cover and front bezel

For your safety, never remove the workstation cover without first disconnecting the power cord from the power outlet and removing any connection to a telecommunications network. If a Power Protection Device is fitted to your workstation, you must shut down your computer using its on/off switch, then remove its power cord before removing the workstation’s cover. Remove the Power Protection Device cables before any servicing operation. Always replace the cover before switching the workstation on again.

24

Chapter 1