1 System Overview
HP Kayak XU700 Minitower Specifications and Characteristics
| If the overload protection in the power supply unit is triggered, all power is |
| immediately cut. To reset the power supply unit, remove the power cord and |
| then determine what caused the overload and remedy it. Reconnect the |
| power cord, then reboot the PC Workstation. If an overload happens twice, |
| then there is an undetected short circuit somewhere. |
|
|
NOTE | When the PC Workstation is turned off with the power button on the front |
| panel, the power consumption falls below the low power consumption (refer |
| to the below table), but is not zero. The special on/off method used by this |
| PC Workstation extends the lifetime of the power supply. To reach zero |
| power consumption in “off” mode, either unplug the PC Workstation from the |
| power outlet or use a power block with a switch. |
|
|
Power Consumption and Cooling
The power consumption and acoustics given in the below table is valid for a standard configuration as shipped (one processor, 256 MB of memory, 320 W power supply, one hard disk drive, graphics card, LAN card).
All information in this section is based on primary power consumptions.
Power consumption (approximate values) |
| 230 V / 50 Hz and 115 V / 60 Hz |
| |||||
• | Typical operating |
|
| 70 W | - 238.8 Btu/h1 |
| ||
• Suspend (only on Windows 2000 models) |
|
| <4 W | - 13.6 Btu/h |
| |||
|
|
|
|
|
|
|
|
|
1. | 1 W = 3.4121 Btu/h |
|
|
|
|
|
| |
|
|
|
|
|
|
| ||
Additional Component: |
|
|
|
|
|
| ||
• | Processor |
| 50 W | - 170.6 Btu/h | ||||
• SCSI Hard disk drive with input/output access |
| 23 W | - 78.4 | Btu/h | ||||
• SCSI Hard disk without input/output access (idle) |
| 16 W | - 54.5 | Btu/h | ||||
• | PCI card |
| 10 to 36 W | - 64.1 | Btu/h to 122.8 Btu/h | |||
|
|
|
|
|
|
|
|
|
17