Red Hat Enterprise Linux (RHEL) Client
To install the HP SAM Linux Client on a system running RHEL version 4 or 5:
1.Log onto the access device using an account with root permissions.
2.Extract the Linux Client tar.gz package onto the system by executing the following terminal command: tar xzvf <name of file.tar.gz>.
3.Run the install script by executing: ./install.sh.
4.After the software is installed, verify the program has been installed into /opt/hpsam.
Customization Steps
(Recommended)
1.Start up the HP SAM client.
When you launch the HP SAM client (by executing /opt/hpsam/hprdclx.sh) your saved settings will take effect.
2.Type the HP SAM web server name.
3.Click Options.
4.Change the appropriate connection settings.
5.Click Save.
Additional settings can be set by manually editing the .SAM files (configuration files).
1.The HP SAM connection client searches first for the
2.It then checks the access device file, /opt/hpsam/hprdc_accessdevice.sam. Parameters found in the access device file replace or are added to the merged file.
3.Then, the connection client checks the file, /opt/hpsam/hprdc_admin.sam. Parameters found in the global file replace or are added to the merged file.
Refer to Configuration Settings on page 38 for a list of the options available for the RHEL Client.
Configuration Settings
Options
There are additional options to configure the settings. You can set these options by manually editing the .SAM file. The following list provides supported keys and values within the [HPRDC] section.
●
●
●
38 Chapter 3 Installation