NOTE: HP SAM 2.2 and earlier clients are not able to connect to Linux resources.

Linux RHEL5 64 bit (update 2 or later)

Linux RHEL6 64-bit

Install and enable one or both of the following:

RGS Sender 5.1.3 or higher with Single Sign-on enabled

Terminal service enabled—RDP

Access Device Requirements

The following sections provide information about the requirements for access devices.

Thin Client

Hardware Requirements

HP Compaq t5720 thin client (with Windows XP Embedded operating system)

HP Compaq t5730 thin client (with Windows XP Embedded operating system)

HP Compaq t5730w (with Windows Embedded Standard (WES) operating system)

HP t5630 thin client (with Windows XP Embedded operating system)

HP t5630w (with Windows Embedded Standard (WES) operating system)

HP t5740 thin client (with Windows Embedded Standard (WES) operating system)

HP t5740e (with Windows Embedded Standard 7 (WES 7) operating system)

HP t5135 thin client (with HP ThinConnect embedded operating system)

HP t5145 thin client (with HP ThinConnect embedded operating system)

HP t5545 thin client (with HP ThinPro operating system)

HP t5745 thin client (with HP ThinPro operating system)

HP gt7725 thin client with (with HP ThinPro GT operating system)

HP gt7720 (with Windows XP Embedded operating system)

HP gt7720w (with Windows Embedded Standard operating system)

If the HP SAM client is preinstalled, you need only to configure the HP SAM client to connect to the appropriate HP SAM Web server.

Software Requirements

Install and enable one or both of the following:

RGS Receiver 5.1.3 or later

RDP

Access Device Requirements

21