6. MENU FUNCTIONS
Test IN
The Test IN function allows you to test how well the robotic lawnmower docks with the charging station.
Test IN can only be performed after Test OUT has been performed.
Selecting this function causes the mower to travel directly along the guide wire towards the charging station and docks with it. The test is approved only if the mower is able to dock with the charging station at the first attempt. If the mower is unable to dock on the first attempt, it will automatically try again. The installation is not approved if the mower needs two or more attempts to dock with the charging station.
Drive past wire
The front of the mower always passes the boundary wire by a specific distance before the mower turns. The default distance is 25 cm, but this can be changed if required. The minimum value is 25 cm and the maximum value is 30 cm.
Now specify the number of centimetres you want the mower to pass the boundary wire and press OK.
Guide width
Remote start 1
Remote start 2 Test settings Drive past wire
6.5 Security |
|
|
Through this selection, settings relating to security |
|
|
Timer |
| |
and the connection between the mower and the |
| |
|
| |
charging station can be made. | Installation |
|
|
| |
Change PIN code |
|
|
Enter the new PIN code and press OK. Enter the | Security |
|
| ||
|
| |
same code again and confirm by pressing OK. When |
|
|
the PIN code is changed, a message stating that the | Settings |
|
PIN code has been changed appears in the display |
|
|
momentarily. |
|
|
|
| |
Make a note of the new PIN code on the designated |
|
|
line in Memo on page 4. |
|
|
Change PIN code
Security level
New loop signal
English - 49
