3. INSTALLATION
6.Connect the guide wire to the boundary wire using a coupler:
Insert the boundary wire in each of the holes in the coupler. Insert the guide wire in the centre hole in the coupler. Check that the wires are fully inserted into the coupler so that the ends are visible through the transparent area on the other side of the coupler.
Use pliers to completely compress the button on the coupler.
It does not matter which holes are used to connect each wire.
7.Staple down/bury the connector in the lawn.
IMPORTANT INFORMATION
The function of the guide wire varies depending on the layout of the working area. This is why it is recommended to test the installation using this function . See
6.4 Installation on page 45.
IMPORTANT INFORMATION
The guide wire may not cross the boundary wire, for instance a boundary wire that is laid out to an island.
3.7 Checking the installation
Check the loop signal by inspecting the indicator lamp on the charging station.
•Solid green light = good signals.
•Flashing blue light = interruption in the boundary loop, no signal.
•Flashing yellow light = interruption in the guide loop, no guide signal.
•Flashing red light = interruption in the charging station's antenna plate. Contact the dealer for assistance, see Memo on page 4.
•Solid blue light = weak signal. This may depend on the boundary loop being too long or that the wire is damaged. If the robotic lawnmower still works, this is not a problem.
•Solid red light = fault in a circuit board in the charging station. The fault should be rectified by an authorized dealer.
See 9.2 Indicator lamp in the charging station on page 66 if the lamp does not indicate a solid green light.
32 - English
