3. INSTALLATION
Laying and connecting the guide wire
1.Run the wire through the slot in the bottom of the charger plate.
2.Fit the connector to the guide wire in the same way as for the boundary wire described in
3.5 Connecting the boundary wire. Connect it to the contact pin on the charging station that is labelled 'Guide'.
3.Run the wire at least 2 metres straight out from the front edge of the plate.
If the guide wire must be laid in a passage:
- The robotic lawnmower follows the guide wire on the same side of the wire to and from the charging station. This means that the robotic lawnmower always runs on the left hand side of the guide wire, as seen facing the charging station.
30 - English
