Husqvarna 308 manual Indicator lamp in the charging station, Light, Troubleshooting, Cause, Action

9. TROUBLESHOOTING

9.2 Indicator lamp in the charging station

For a fully functional installation, the indicator lamp in the charging station must emit a solid green light. If something else appears, follow the troubleshooting guide below.

There is more troubleshooting help on www.automower.com. If you still need help with troubleshooting, please contact the local dealer.

Light	Cause	Action
Solid green light	Everything in order	No action required
Blue flashing light	The boundary wire is not connected	Check that the boundary wire
	to the charging station	connector is fitted properly to the
		charging station. See 3.5 Connecting
		the boundary wire on page 28.
	Break in the boundary wire.	Find out where the break is. Replace
		the damaged section of the boundary
		wire with a new loop wire and splice
		using an original coupler.
Yellow flashing light	The guide wire is not connected to	Check that the guide wire connector
	the charging station	is properly connected to the charging
		station. See 3.6 Installation of the
		guide wire on page 29.
	Break in the guide wire	Find out where the break is. Replace
		the damaged section of the guide
		wire with a new loop wire and splice
		using an original coupler.
Red flashing light	Interruption in the charging station's	Contact the local dealer.
	antenna
Solid blue light	Weak signal as the boundary wire is	No steps have to be taken if the
	too long. Max length is 250 metres.	mower operates as expected.
		Shorten the boundary wire by
		reducing the working area or
		replacing islands with barriers the
		mower can collide with.
	Weak signal due to damaged	Since it is difficult to locate where the
	boundary wire	wire is damaged it is recommended
		to lay a new boundary wire for the
		entire working area.
Solid red light	Defective circuit board in the charging	Contact the local dealer.
	station

66 - English