Husqvarna 965030296, 965030298, 1018855-26 manual Tank Unit, Dismantling, Cleaning and Inspection

TANK UNIT

Dismantling

Empty the tank and dismantle the cylinder cover as well as the bar and chain.

Loosen the fuel pipe and disconnect the throttle cable if fitted.

!WARNING!

The fuel used in the chain saw poses the following hazards:

1.The liquid and its vapours are poisonous.

2.Can cause skin irritation.

3.Is highly inflammable.

The figures on the next page illustrate all types of mountings between the tank unit and the engine sub-assembly marked by letters.

The mountings applying to the chain saw in question is evident from the table on the next page.

If heated handles are fitted remove the con- nections.

The cable to the switch cannot be removed before the tank unit and the engine sub- assembly are separated.

NOTE!

Take care that the fuel pipe and throttle cable are not damaged.

Dismantle the bolts as shown in the figures and the table on the next page and lift off the tank unit from the engine sub-assembly.

Cleaning and Inspection

Clean all parts and check the following:

•That the fuel pipe is undamaged.

•That the tank unit is not cracked.

•That the throttle cable runs freely.

•That the AV-system is undamaged For AV- system see page 107.

•That the tank breather is not blocked or leaks.

•That the fuel cap does not leak.

•That the fuel pipe bushing seals

•That the fuel filter is not blocked.

If the fuel pipe needs to be replaced, meas- ure its length outside of the tank unit and make a note of the length. This information is needed when fitting a new pipe.

English – 103