Husqvarna 965030298, 965030296, 1018855-26 manual Piston And Cylinder, Dismantling, English

PISTON AND CYLINDER

Dismantling

Dismantle the following parts:
• Cylinder cover. See operating instructions.	• Carburettor.
• Spark plug. See operating instructions.	• Muffler.

Saws 36, 40, 41 and 45.

Other saws

Dismantle the insulation plate between the cylinder and the carburettor and the intake manifold.

Remove the cables to the ignition coil.

Remove the ignition coil.

On saw 394, disconnect the anti-vibration spring (A) from the cylinder.

On all chain saws, undo the four cylinder bolts (B). The bolts are removed using a 4

mmallen key (smaller saws) or 3/16” allen key (larger saws).

BA

Saws 36 and 41.

Saws 40 and 45.

NOTE!

Ensure that no dirt or other foreign particles fall into the crankcase.

Dismantle the tank unit. See page 102.

Undo the four bolts under the crankcase.

Carefully lift up the cylinder.

Remove the needle bearing from the little end of the connecting rod. Remove the decompression valve if fitted.

Immediately cover the crankcase opening/ crankshaft and crankshaft bearing with a paper or cloth.

Remove one of the circlips on the piston push out the gudgeon pin and remove the piston.

108 – English