Husqvarna 965030298, 965030296, 1018855-26 manual Tank Unit, Assembly

TANK UNIT

Assembly

If a new fuel pipe is to be fitted proceed as follows:

1.Measure the length of the old hose out- side of the tank unit, note the length.

2.Oil half of the hose lightly and thread the oiled part into the fuel tank from the outside.

3.Twist the hose so that it takes on the same angle to the carburettor and let the hose protrude as much as the old hose did.

4.Pull the hose through the filler hole using tool 502 50 83-01, cut off the bevelled end and fit the fuel filter.

Fit the throttle and lock.

NOTE!

Ensure that the fuel pipe and throttle cable are not damaged.

Fit the engine sub-assembly to the tank unit and at the same time insert the fuel pipe in the bottom of the carburettor space.

If the saw has a throttle cable, insert this into the carburettor space too.

Make the handle heater connections if nec- essary.

The figures on the previous page illustrate all types of mountings between the tank unit and the engine sub-assembly marked by letters.

The mountings applying to the chain saw in question is evident from the table on the next page.

Fit the bolts as set out in the table on the previous page. Tightening torques, see the service data for the saw in question.

Connect the fuel pipe and the throttle cable to the carburettor.

Fit the cylinder cover and the chain and bar.

English – 105