Husqvarna 965030296, 965030298, 1018855-26 manual Bar bolts, Crankcase And Crankshaft

CRANKCASE AND CRANKSHAFT

Bar bolts

When changing the bar bolts on all saws except 40 and 45 proceed as follows:

1.Drain the chain oil.

2.Knock through the old bar bolt so that it falls in the oil tank.

3.Remove the bolt from the oil tank.

4.Attach a steel wire to the end of the new bar bolts, thread the wire through the oil tank and out through the bolt hole in the crankcase.

5.Pull the steel wire until the bolt comes out through its hole.

6.Check that the bolt’s square shoulder is aligned with its recess in the crankcase. Turn the bolt if necessary.

7.Pull through the bolt with its nut and spacer between the nut and crankcase.

8.Refill with chain oil.

English – 121