Husqvarna 965030298, 965030296, 1018855-26 manual Centrifugal Clutch, Assembly

CENTRIFUGAL CLUTCH

Assembly

Grease the needle bearing (C) and fit onto the crankshaft. Then fit the clutch drum.

NOTE! The bearing can also be greased later through the hole on the crankshaft.

To prevent imbalance all clutch shoes should be replaced at the same time.

C

Saws with three coil springs.

Saws with one long spring.

Saws with three C-springs.

NOTE! The clutch springs should not be opened out more than necessary. Risk of deformation.

Locate the clutch shoes on the hub and fit the springs with the help of pliers.

Locate the clutch shoes on the hub. Lift a shoe using a suit- able spacer (A) and fit the

spring.

A

Locate the clutch shoes on the hub and fit the springs with the help of circlip pliers.

Using a spanner secure the clutch centre. On saws 36 and 41 use service tool no. 530 03 11-12.

Note! Left-hand thread.

Remove the piston stop and fit the spark plug.

Fit the chain and bar. See the operating instruc- tions. On 268K and 272K, fit the cutting attach- ment.

See the operating instructions.

English – 69