Husqvarna Pro 15 manual Transmission, Replacing the oil filter, Lubrication

LUBRICATION

12. Transmission

The oil and filter should be replaced by an authorised service workshop as described in the workshop manual.

13. Replacing the oil filter

WARNING!

The engine oil may be very hot if it is drained immediately after stopping the engine. Let the engine cool down for a while first.

1.Release the rubber strap under the seat and raise the engine hood.

2.Drain the engine oil as described under “Changing the engine oil”.

3.Remove the oil filter. If necessary use a filter spanner.

4.Coat the seal on the new filter with clean, fresh engine oil.

5.Tighten the filter by hand until you feel it make contact, then tighten a further 3/4 turn.

6.Run the engine until it is hot, then check that there is no leakage from the oil filter seal.

7.Check the engine oil level and top up if necessary. The oil filter holds 0.2 litres of oil.

IMPORTANT INFORMATION

Dispose of used filters at a recycling station.

Used engine oil is a health hazard and must not be emptied onto soil or in the countryside.

Filters and oil must be taken to a work- shop or other suitable place where they can be disposed of safely.

Avoid skin contact, wash with soap and water in the event of spillage.

English – 47