Husqvarna Pro 15 Replacing the air filter, Do not use compressed air to clean the paper filter

MAINTENANCE

Replacing the air filter

If the engine seems to lack power or does not run smoothly this may be because the air filter is clogged.

It is therefore important to replace the air filter at regular intervals (see maintenance schedule on page 19-20 for correct service interval).

Clean/ replace the air filter as follows:

1.Release the rubber strap under the seat and raise the engine hood.

WARNING!

Let the exhaust system cool down before servicing it, otherwise you could burn yourself.

2. Fold out the two snap-locks and lift off the cover on the air filter housing.

3. Pull off the foam plastic pre-filter from the paper filter and wash clean in mild detergent.

Squeeze it dry in a clean cloth.

4. Unscrew the wing nut from the air filter and lift out the paper filter. Tap the filter against a hard surface to shake off the dust. If the paper filter is still dirty it should be replaced.

IMPORTANT INFORMATION

Do not use compressed air to clean the paper filter.

Do not wash the paper filter.

Do not oil the paper filter.

5. Refit the air filter as follows:

Insert the paper filter in the air filter housing and tighten the wing nut.

6.Fit the pre-filter over the rectangular section of the paper filter.

7. Refit the cover on the air filter housing. Bring up the cover from below and make sure the pre- filter does not drop out of place. Secure with the two clips.

English – 25