P/N 0420057_B |
GLASS POSITIONING
Check the following to improve opening or clos- ing of the case front glass.
1.Has the case been leveled according to preceding paragraphs?
2.Is the glass handle installed correctly?
Verify the glass is bottomed out the length of the handle. A bowed handle indicates the glass may not be bottomed out at the center of the handle.
The handle must be removed before it can be repositioned. The handle is held in place with silicone which must be completely removed from the handle and the glass. Remove the handle by pulling it away from the glass (do not use tools to pry this loose). A damaged or bent handle must be replaced. Apply new silicone into the handle and firmly press onto the glass.
3.Is the glass seated in the clamp hardware correctly?
Verify glass is bottomed out in clamp hardware.
If the glass is not bottomed out in the clamp hardware it can be
A.Remove the glass and clamp hardware from the case by opening the glass and loosening set screws in hinge, (Metric 3 millimeter set screws).
B.Slide the glass and clamp hardware to the side out of the hinges and lay them on an appropriate work surface.
Note: adjacent glass must be closed.
C.Loosen the 8 set screws on the underside of the clamp hardware.
D.Push the clamp hardware onto the glass until bottomed out.
E.The clamp hardware must overhang the glass by an equal amount on each side.
F.Tighten
HUSSMANN CORPORATION, Bridgeton, MO | Service Merchandisers |
