4.Is the glass hitting the end or adjacent glass? Slowly open and close the glass to inspect.
If the glass is hitting the end or adjacent glass it may not be positioned correctly from left to right. This can be adjusted as follows:
•Loosen the 2 screws holding the hinge to the clamp hardware (Metric 3 millimeter screws).
•Slide the clamp hardware to either side as needed.
•Tighten the screws and check glass for proper operation.
5.Is the glass still hitting adjacent glass? Slowly open and close the glass to inspect.
Optional Flexible Wiper Gasket
There may be an optional flexible wiper gasket that is attached to each side. These are designed to overlap each other, sealing the gap between the glass and allowing
Optional Flexible Wiper Gasket
Glass
ADJUSTMENT BOLT
If the glass still does not open or close correctly, adjustment of the top frame may be necessary.
This case is equipped with an adjustment bolt at the top rear of the case to raise or lower the glass. This allows for improvements in the glass operation and sealing. The following outlines how to access the adjustment bolt. The top must be free to move as the adjustment bolt is turned.
1.Loosen joining or end bolts at top of case, (2 at each end of case).
2.If caulk or silicone has been applied between case joints or ends in the top area it must be removed.
3.Remove rear doors.
P/N 0420057_B | U.S. & Canada |