P/N 0420057_B
REPLACING GLASS HAND GRIP
The hand grip is fastened to the curved glass as shown below. A 2 inch (51 mm) bead of silicone needs to be placed 3 inches (76 mm) from each end and in the center of the hand grip. The duct tape is placed on the glass to provide a tight fit.
Type: Two cylinders and three fastening points. P/N 0407352
Used on: 30° outside wedge.
Duct Tape
Glass
3/8 in. (10 mm) of Duct Tape on Each Side of Bottom Edge of Glass
3/8 in. (10 mm)
Type: Three cylinders and four fastening points. P/N 0412538
Used on 90° inside wedge, 45° outside and inside wedge, 30° inside wedge.
| Start 2 in. (51 mm) |
| Silicone Bead |
3 in. | 3 in. (76 mm) |
(76 mm) | From Each End |
| Glass Grip |
Note: This hinge assembly, when used on the 90° and 45° inside wedge, uses only two cylinders.
HINGE HARDWARE
Type: Two cylinders and one fastening point. P/N 0401884
Used on: 8 ft and 12 ft (2438 mm and 3658 mm) parent cases and as a joining bracket.
Type: Four cylinders and five fastening points. P/N 0413170
Used On: 90° outside wedge.
HUSSMANN CORPORATION, Bridgeton, MO | Service Merchandisers |