IBM 6643 Diagnostic Error Code FRU/Action 170-195-XXX Information, XXX Power supply 170-251-XXX

Diagnostic Error Code	FRU/Action
170-195-XXX	1.	Information
Voltage Sensor(s) Test aborted by user
	2.	Re-start the test, if necessary
170-196-XXX	1.	Press F3 to review the log file
Voltage Sensor(s) test halt, error threshold
	2.	Re-start the test to reset the log file
exceeded
170-197-XXX	1.	Make sure the component that is called
Voltage Sensor(s) test warning
		out is connected and/or enabled
	2.	Re-run test
	3.	Component that is called out in warning
		statement
	4.	Component under test
170-198-XXX	1.	If a component is called out, make sure
Voltage Sensor(s) test aborted
		it is connected and/or enabled
	2.	Flash the system and re-test
	3.	Go to the ″Undetermined problems″
		section
170-199-XXX	1.	Go to the ″Undetermined problems″
Voltage Sensor(s) test failed, cause unknown
		section
	2.	Flash the system and re-test
	3.	Replace component under function test
170-250-XXX	1.	Power supply
170-251-XXX
	2.	System board
Voltage Sensor(s) Voltage limit error
170-254-XXX	1.	Voltage Regulator Module (VRM)
Voltage Sensor(s) Voltage Regulator Module
	2.	Microprocessor
error
	3.	System board
175-000-XXX	1.	No action
Thermal Sensor(s) Test Passed
175-0XX-XXX	1.	Flash system
Thermal Sensor(s) failure
	2.	System board
175-195-XXX	1.	Information
Thermal Sensor(s) Test aborted by user
	2.	Re-start the test, if necessary
175-196-XXX	1.	Press F3 to review the log file
Thermal Sensor(s) test halt, error threshold
	2.	Re-start the test to reset the log file
exceeded
175-197-XXX	1.	Make sure the component that is called
Thermal Sensor(s) test warning
		out is connected and/or enabled
	2.	Re-run test
	3.	Component that is called out in warning
		statement
	4.	Component under test
175-198-XXX	1.	If a component is called out, make sure
Thermal Sensor(s) test aborted
		it is connected and/or enabled
	2.	Flash the system and re-test
	3.	Go to ″Undetermined problems″ section

52Hardware Maintenance Manual