IBM 2179, 6643 manual Diagnostic Error Code

Diagnostic Error Code	FRU/Action
015-002-XXX	1.	Remove USB device(s) and re-test
USB port Timeout
	2.	System board
015-015-XXX	1.	Remove USB device(s) and re-test
USB port External Loopback failure
	2.	System board
015-027-XXX	1.	Flash the system
USB port Configuration/Setup error
	2.	System board
015-032-XXX	1.	System board
USB port Device Controller failure
015-034-XXX	1.	Reboot the system
USB port buffer
	2.	Flash the system
allocation failure
	3.	Run memory test
	4.	System board
015-035-XXX	1.	Remove USB device(s) and re-test
USB port Reset condition detected
	2.	System board
015-036-XXX	1.	System board
USB port Register error
015-040-XXX	1.	Run setup and check for conflicts
USB port IRQ failure
	2.	Flash the system
	3.	System board
015-195-XXX	1.	Information
USB port Test aborted by user
	2.	Re-start the test, if necessary
015-196-XXX	1.	Press F3 to review the log file
USB port test halt, error threshold exceeded
	2.	Re-start the test to reset the log file
015-197-XXX	1.	Make sure the component that is called
USB port test warning
		out is connected and/or enabled
	2.	Re-run test
	3.	Component that is called out in warning
		statement
	4.	Component under test
015-198-XXX	1.	If a component is called out, make sure
USB port test aborted
		it is connected and/or enabled
	2.	Flash the system and re-test
	3.	Go to the ″Undetermined problems″
		section
015-199-XXX	1.	Go to the ″Undetermined problems″
USB port test failed, cause unknown
		section
	2.	Flash the system and re-test
	3.	Replace component under function test
018-000-XXX	1.	No action
PCI Card Test Passed
018-0XX-XXX	1.	Riser card if installed
PCI Card Failure
	2.	System board

Chapter 5. Symptom-to-FRU Index 45