Identifying problems with the FlipTouchdisplay
Toanalyze a problem with the FlipTouch display, do the
following:
1. Make sure that the FlipTouchdisplay is enabled:
vIBM BIOS Setup Utility --> Config --> FlipTouch
Display
2. Insert the PC-Doctor DOS disk in the diskette drive,
and turn on the system unit. For details on using
PC-Doctor,see “Testing the computer”on page 26.
3. Run Diagnostics and select FlipTouchdisplay.Ifthe
test fails, one or both of the following are defective:
vLCD panel 10.4-in. TFTwith touch panel (05K9623)
vLCD cable (27L0544)
4. Run Interactive Testsand select FlipTouch display.
If one or more the positions were not detected properly,
one or both of the following are defective.
vLCD panel 10.4-in. TFTwith touch panel (05K9623)
vLCD cable (27L0544)
Identifying problems with theThinkScribe digital notepad
Toanalyze a problem with the ThinkScribe digital notepad,
do the following:
1. Make sure that the ThinkScribe digital notepad is
enabled:
vIBM BIOS Setup Utility --> Config --> ThinkScribe
2. Insert the PC-Doctor DOS disk in the diskette drive,
and turn on the system unit. For details on using
PC-Doctor,see “Testing the computer”on page 26.
While PC-Doctor DOS is starting up, turn the
ThinkScribe digital notepad off and on. If the error
message ″ThinkScribe not detected″is displayed, do
the following;
a. Turnoff the ThinkScribe digital notepad.
b. Start the ThinkScribe POSTby doing the following:
vPress and hold the power button on the
ThinkScribe digital notepad.
vPush the reset switch on the ThinkScribe digital
notepad.
vWhile continuing to press and hold the power
button, wait for 20 seconds.
If no error message appears on the LCD, the
notepad has passed all the tests of ThinkScribe
POST.The problem must be one of the following:
vThe System-Digi cable (27L0556) is not
connected properly.
vThe System-Digi cable (27L0556) is defective.
If an error message does appear on the LCD,
Symptom-to-FRUindex
ThinkPad TransNote 47