Initio I/O HIGHWAY manual Control Panel

33

Microsoft Windows NT Driver Installation

3In the INSTALL DRIVER window, select “HAVE DISK...”.

4In the INSTALL FROM DISK window that is displayed, enter the Initio Driver path name:

•Insert INI-9XXXU/9XXXUW DRIVER DISK 1 into drive A:

•Type: A:\WINNT, select “OK”

5Select Initio INI-9XXXU/UW PCI SCSI Host Adapter, select “OK” to install the INI910U.SYS driver onto your hard disk drive.

6In the WINDOWS NT SETUP window that is displayed, enter the Initio Driver path name to continue:

•Type: A:\WINNT, select “CONTINUE”

7This completes updating the Host Adapter Driver. Follow the on-screen directions to restart you computer and activate the new driver

8It is highly recommended that you verify Initio’s Windows NT device driver has been properly installed by selecting MY COMPUTER from the desktop. Then select

CONTROL PANEL:

•Select SCSI ADAPTERS from within the CONTROL PANEL group,

•Select Initio INI-9XXXU/UW PCI SCSI Host Adapter from within the SCSI CONTROLLER listing. If “This device is working properly” is displayed on your screen, the driver has been correctly installed.

Installing a new Windows NT system and Initio driver without floppy disks

For computer systems installing or upgrading to Windows NT from a floppyless setup such as a share on your network, these instructions will guide you through the INI- 9XXXU/9XXXUW host adapter driver installation. The Windows NT drivers are located on the INI-9XXXU/9XXXUW DRIVER DISK 1. It is important that the hardware has been installed successfully before proceeding further.

1Execute a floppyless setup as described by the Windows NT System Administrator’s Guide

initio®