36
initio
®
6Select installation type. <ENTER>
7Enter server name when prompted <ENTER>
At this point the boot files will be copied to the hard drive.
8After the files are finished being copied you may encounter the following message:
Install found the following hardware but found
More than one driver supporting this hardware
PCI.XXXX.XXXX.XXXX.XXXX.XX
Press <Enter> for a list of drivers to choose
From or <F3> to continue without selecting
Press <F3> to continue. Repeat if this screen is shown again.
9A screen listing the drivers will be displayed. INI9100 will be listed as the selected
driver. This completes loading the Host Adapter Driver, Follow the on-screen direc-
tions to complete the Novell NetWare installation.
This will load the HAM driver. If a DSK driver is required or an updated HAM driver is
needed it is recommended that you complete the installation and use NetWares
INSTALL utility to update/change the driver.
Adding the Initio driver to an existing IntraNetWare sys-tem
1To begin the installation you will need to change the directory to the location of the
server and initialize the network server, e.g.,
Type CD \ NWSERVER <ENTER>
Type SERVER <ENTER>
2At the NetWare prompt, Type LOAD INSTALL <ENTER>.
3Select Driver Options from the window by highlighting it using the UP or DOWN
ARROW keys, press <ENTER>
 Select Configure disk and storage device drivers from the window by high
lighting it using the UP or DOWN ARROW keys, press <ENTER>
4Highlight Discover and load additional drivers and press <ENTER>
5NetWare will load INI9100.HAM modify the STRATUP.NCF file to reflect the new
changes.
Novell NetWare Driver Installation