Integra DTR-5.8 instruction manual Turning On the AV Receiver, Turning On and Standby

Turning On the AV Receiver

Standby/On

Receiver

Standby indicator

Standby/On

Connecting the Power Cord

• Connect the AV receiver’s power cord to a suitable wall outlet.

Notes:

•Before connecting the power cord, connect all of your speakers and AV components.

•Turning on the AV receiver may cause a momentary power surge that might interfere with other electrical equipment on the same circuit. If this is a problem, plug the AV receiver into a different branch circuit.

Turning On and Standby

1

AV receiver	Remote
	controller

or

Press the [Standby/On] button.

Alternatively, press the remote controller’s [Receiver] button, followed by the [Standby/On] button.

The AV receiver comes on, the display lights up, and the Standby indicator goes off.

To turn the AV receiver off, press the [Standby/On] button, or press the remote control- ler’s [Standby/On] button. The AV receiver will enter Standby mode. To prevent any loud surprises when you turn on the AV receiver, always turn down the volume before you turn it off.

Smooth Operation in a Few Easy Steps

To ensure smooth operation, here’s a few easy steps to help you configure the AV receiver before you use it for the very first time. These settings only need to be made once.

■ Do the automatic speaker setup—this is essential!

See “Automatic Speaker Setup (Audyssey 2EQ)” on page 41.

■Have you connected a component to an HDMI input,

component video input, or digital audio input? HDMI

If you have, see “HDMI Input Setup” on page 48, “Component Video

Setup” on page 49, or “Digital Input Setup” on page 50 respectively.

■Have you connected an Integra MD recorder, CD recorder,

OUT IN

or RI Dock?

If you have, see “Changing the Input Display” on page 51.

TAPE

CD recorder, MD recorder,

RI Dock

40