Manuals / Integra / Home Audio / Stereo Receiver

Integra DTR-5.8 Listening to the Radio, Using the Tuner, Tuning into Radio Stations

Models: DTR-5.8

1 100
Download 100 pages 21.79 Kb
Page 57
Image 57
Listening to the Radio

Listening to the Radio

Using the Tuner

With the built-in tuner you can enjoy AM and FM radio stations. You can store your favorite stations as presets for quick selection.

Listening to the Radio

Use the [Tuner] input selector button to select either AM or FM.

In this example, FM has been selected. Each time you press the [Tuner] button, the input source changes between AM and FM.

Band Frequency

(Actual display depends on country)

Tuning into Radio Stations

1

2

■ Auto Tuning Mode

1

 

Press the [Tuning Mode] button

 

 

 

 

so that the AUTO indicator

 

 

appears on the display.

 

 

2Press the Tuning Up or Down

[Using the Tuner]/[ ] buttons.

Searching stops when a station is found.

When tuned into a station, the TUNED indicator appears. When tuned into a stereo FM station, the FM STEREO indicator appears on the display, as shown.

FM STEREO

AUTO TUNED

■ Manual Tuning Mode

1

 

Press the [Tuning Mode] button

 

 

 

 

so that the AUTO indicator disap-

 

 

pears from the display.

 

 

2Press and hold the Tuning Up or

Down [Tuning into Radio Stations]/[ ] buttons.

The frequency stops changing when you release the button.

Press the buttons repeatedly to change the frequency one step at a time.

The North American models change FM frequency in

0.2MHz steps, 10 kHz steps for AM. For other models it’s 0.05 MHz steps for FM and 9 kHz steps for AM. In Manual Tuning mode, FM stations will be in mono.

Tuning into weak FM stereo stations

If the signal from a stereo FM station is weak, it may be impossible to get good reception. In this case, switch to Manual Tuning mode and listen to the station in mono.

■Tuning into Stations by Frequency

You can tune into AM and FM stations directly by enter- ing the appropriate frequency.

1Press the [Receiver] button, fol- lowed by the [D TUN] button.

(Actual display depends on country.) The [Receiver] button flashes.

2Within 8 seconds, use the num- ber buttons to enter the fre- quency of the radio station.

For example, to tune to 87.5 (FM), press 8, 7, 5.

Note: While the [Receiver] button is flashing, the input source cannot be changed by using the remote controller.

57

Page 56 Page 58
Page 57
Image 57
Integra DTR-5.8 Listening to the Radio, Using the Tuner, Tuning into Radio Stations, Tuning into weak FM stereo stations
Page 56 Page 58