Integra DTR-5.8 2 3 4 5 6, 1 3 2, 2, 4, Source Setup, IntelliVolume, Advanced Setup—Continued

Advanced Setup—Continued

5When you’ve finished, press the [Setup] button.

The setup menu closes.

Note:

This procedure can also be performed on the AV receiver by using its [Setup] button, arrow buttons, and [Enter] button.

Source Setup

1

3

2, 4

2, 4, 5

1, 6

IntelliVolume

You can set the input level for each input source. This is useful if some of your AV components are louder or qui- eter than others. IntelliVolume does not affect Zone 2.

While this menu is shown onscreen, you can select each input source and set the levels while listening to and comparing them.

1Press the [Receiver] button fol- lowed by the [Setup] button.

The main menu appears onscreen.

2

3

4

5

6

Use the Up and Down []/[ ] buttons to select “4. Source Setup,” and then press [Enter].

The Source Setup menu appears.

4. Source Setup

DVD

1.IntelliVolume

2.A/V Sync

Use the Input Selector buttons on the remote controller to select the input source that you want to set.

Use the Up and Down []/[ ] buttons to select

“1. IntelliVolume,” and then press [Enter].

The IntelliVolume menu appears.

4–1. IntelliVolume

DVD

IntelliVolume0dB

If a component is too loud com- pared to your other components, use the Left [] button to adjust the level. If it’s too quiet, use the Right [ ] button.

•The level can be set from –12 dB to +12 dB in 1 dB steps.

When you’re finished, press the [Setup] button.

The setup menu closes.

77