Integra DTR-5.8 instruction manual Multichannel DVD Input Settings, Subwoofer Input Sensitivity

Advanced Setup—Continued

7Use the Up [] button to select “Channel,” and then use the Left

and Right []/[ ] buttons to select another speaker.

Repeat step 6 and 7 for each speaker.

8Press the [Setup] button.

The setup menu closes.

Notes:

•When the listening mode is set to Direct, no effect will be produced.

•Depending on the input source or listening mode, the Equalizer settings may not produce the desired effect.

•This procedure can also be performed on the AV receiver by using its [Setup] button, arrow buttons, and [Enter] button.

Multichannel DVD Input Settings

Subwoofer Input Sensitivity

Some DVD players output the LFE channel from their subwoofer output at 15 dB higher than normal. You can change the subwoofer sensitivity to match your DVD player. Note that this setting only affects signals con- nected to the SUBWOOFER input jack of the multichan- nel DVD input.

1Press the [Receiver] button fol- lowed by the [Setup] button.

The main menu appears onscreen.

2 Use the Up and Down []/[ ] buttons to select “7. Hardware Setup,” and then press [Enter]. The Hardware Setup menu appears.

7. Hardware Setup

1.Remote Control

2.Zone2

3.Tuner

4.Analog Multich

5.HDMI

3	Use the Up and Down [ ]/[ ]
	buttons to select “4. Analog Mul-
	tich,” and then press [Enter].
	The Analog Multich menu appears.
	7–4. Analog Multich
	Subwoofer Input Sensitivity	0dB

4 Use the Left and Right [ ]/[ ]

buttons to select a value.

You can select 0 dB, 5 dB, 10 dB, or 15 dB.

If you find that your subwoofer is too loud, try the 10 dB or 15 dB setting.

5Press the [Setup] button.

The setup menu closes.

Note:

This procedure can also be performed on the AV receiver by using its [Setup] button, arrow buttons, and [Enter] button.

73