Connecting Your
Connecting Integra/Onkyo Components
Step 1: Make sure that each Integra/Onkyo component is connected to the AV receiver with an analog audio cable (RCA).
Step 2: Make the necessary connections (see illustration below).
Step 3: If you’re using an MD, CDR, or RI DOCK component, change the Input Display (see page 46).
With (Remote Interactive), you can use the following special functions:
Auto Power On/Standby
When you start playback on a component connected via , if the AV receiver is on Standby, it will automatically turn on and select that component as the input source. Similarly, when the AV receiver is set to Standby, all components
connected via will also go on Standby.
Direct Change
When playback is started on a component connected via , the AV receiver automatically selects that component as the input source. If your DVD player is connected to the AV receiver’s DVD IN (multichannel input), you’ll need to press the [Multi CH] button repeatedly and select Multich to hear all channels (see page 48), as the Direct Change function selects the DVD IN FRONT L/R jacks.
Remote Control
You can use the AV receiver’s remote controller to control your other
Notes:
•Use only cables for connections. cables are supplied with Integra/Onkyo players (DVD, CD, etc.).
•Some components have two jacks. You can con- nect either one to the AV receiver. The other jack is
for connecting additional
•Connect only Integra/Onkyo components to jacks. Connecting other manufacturer’s components may cause a malfunction.
•Some components may not support all functions. Refer to the manuals supplied with your other Inte- gra/Onkyo components.
•While Zone 2 is on, the Auto Power On/Standby and
Direct Change functions do not work.
IN
SIRIUS | AM L |
ANTENNA | R |
FM |
|
75 | CD |
| |
| FRONT |
REMOTE | L |
| |
CONTROL |
|
| R |
| DVD |
e.g., CD player |
|
R | L |
ANALOG | |
AUDIO OUT | |
e.g., DVD player |
|
R | L |
ANALOG | |
AUDIO OUT |
37