Integra DTR-5.9 instruction manual Advanced Setup—Continued, Notes

Advanced Setup—Continued

■Audio TV Out

This setting determines whether audio received by an HDMI input is output by the HDMI outputs. You may want to change this setting to On if your TV is connected to an HDMI output and you want to listen to audio from an HDMI component through your TV’s speakers. Nor- mally, it should be set to Off.

Off: HDMI audio is not output (default).

On: HDMI audio is output.

Notes:

•If On is selected and the signal can be output by the TV, the AV receiver will output no sound through its speakers.

•When TV Control is enabled, this setting is set to Auto.

•With some TVs and input signals, no sound may be output even if On is selected.

•When the Audio TV Out setting is set to On, or TV Control is set to Enable and you’re listening through your TV’s speakers (see page 32), if you turn up the AV receiver’s volume control, the sound will be output by the AV receiver’s speakers. To stop the AV receiver’s speakers producing sound, change the set- tings, change your TV’s settings, or turn down the AV receiver’s volume.

■Lip Sync

The Lip Sync function can automatically synchronize HDMI audio and video that’s gotten out of sync due to the complex digital video processing being performed by your HDMI-compatible TV. With HDMI Lip Sync, the audio delay required to synchronize the audio and video is calculated and applied automatically by the AV receiver.

Disable: HDMI lip sync disabled.

Enable: HDMI lip sync enabled.

Notes:

•This function works only if your HDMI-compatible TV supports HDMI Lip Sync.

•You can check the amount of delay being applied by the HDMI Lip Sync function on the A/V Sync screen (see page 87).

■x.v.Color

If your HDMI source and HDMI-compatible TV both support the “x.v.Color,” you can enable “x.v.Color” on the AV receiver with this setting.

Disable: “x.v.Color” disabled.

Enable: “x.v.Color” enabled.

■Control

This function allows RIHD-compatible components connected via HDMI to be controlled with the AV receiver.

Disable: RIHD disabled.

Enable: RIHD enabled.

Notes:

•RIHD, which stands for Remote Interactive over HDMI, is the name of the system control function found on Integra/Onkyo components. The AV receiver can be used with CEC (Consumer Electronics Con- trol), which allows system control over HDMI and is part of the HDMI standard. CEC provides interopera- bility between various components, however, opera- tion with components other than RIHD-compatible components and recommended components cannot be guaranteed.

•Select Disable if a connected component is incompat- ible or you’re not sure about its compatibility.

•If operation is unreliable when set to Enable, select Disable instead.

Power Control

To link the power functions of RIHD-compatible com- ponents connected via HDMI, select Enable.

Disable: Power Control disabled.

Enable: Power Control enabled.

Notes:

•The Power Control setting can be set only when the above Control setting is set to Enable.

•HDMI power control only works with RIHD-compat- ible components that support it and may not work properly with some components due to their settings or compatibility.

•When set to Enable, the AV receiver consumes more power.

•When set to Enable, the AV receiver enters Ready mode when set to Standby, and the Standby indicator lights up.

•When set to Enable, regardless of whether the AV receiver is On or on Standby, both audio and video received by an HDMI input will be output by the HDMI OUT for playback on the TV or other compo- nent that’s connected to the HDMI OUT.

91