Intel CB60-ZX, CB60-BX manual Hardware Installation Wake-On-LAN Connector

Hardware Installation

2.7.12 Wake-On-LAN Connector

The system board supports the Wake-On-LAN function.This function will allow the network to remotely power-on a Soft Power Down (Soft-Off) PC. However, if your system is in the Suspend mode, you can power-on the system only through an IRQ or DMA interrupt.

To use the Wake-On-LAN function, you must enable the “Resume on LAN” field in the Power Management Setup of the Award BIOS. Your LAN card package should include a cable. Connect one end of the cable to the wakeup header on the card and the other end to location J15 on the system board. The network will detect Magic Packet and assert a wakeup signal to power-up the system. Refer to the add-in card’s manual for details. Note: Your LAN card must support the remote wake up function.

2

Pin Function

1+5VSB (720mA)

2	Ground
3	WOL

Important:

The 5VSB power source of your power supply must support ≥720mA (minimum).

23