Bit 4: Voltage Enabled

The Disable Voltage request is active when the voltage_disabled bit is cleared to 0.

Bit 5: Quick Stop Active

When reset, this bit indicates that the drive is reacting on a quick stop request. Bits 0, 1 and 2 of the statusword must be set to 1 to indicate that the drive is capable to regenerate. The setting of the other bits indicates the status of the drive (e.g. the drive is performing a quick stop as result of a reaction to a non-fatal fault. The fault bit is set as well as bits 0, 1 and 2).

Bit 7: Warning

A drive warning is present if bit 7 is set. The cause means no error but a state that has to be mentioned, e.g. temperature limit, job refused. The status of the drive does not change. The cause of this warning may be found by reading the fault code parameter. The bit is set and reset by the device.

Bit 8: Manufacturer Specific

This bit may be used by a drive manufacturer to implement any manufacturer specific functionality.

Bit 9: Remote

If bit 9 is set, then parameters may be modified via the CAN-network, and the drive executes the content of a command message. If the bit remote is reset, then the drive is in local mode and will not execute the command message. The drive may transmit messages containing valid actual values like a position_actual_value, depending on the actual drive

configuration. The drive will accept accesses via service data objects (SDOs) in local mode.

Bit 10: Target Reached

If bit 10 is set by the drive, then a setpoint has been reached (torque, speed or position depending on the modes_of_op- eration). The change of a target value by software alters this bit. If quickstop_option_code is 5, 6, 7 or 8, this bit must be set, when the quick stop operation is finished and the drive is halted. If Halt occured and the drive has halted then this bit is set too.

Bit 11: Internal Limit Active

This bit set by the drive indicates, that an internal limitation is active (e.g. position_range_limit).

Bits 12-13: Operation Mode Specific

Operation Mode

Statusword 6041h

Bit 12

Bit 13

 

Profile Position

Set Point

Following Error

 

Acknowledge

 

Profile Velocity

Speed

Max Slippage Error

Homing*

Homing Attained

Homing Error

*Homing Mode is currently under development for the MDrivePlus CANopen

Table 4.6: MDrivePlus CANopen Operation Mode Status

Bit 14-15: Manufacturer Specific

These bits may be used by a drive manufacturer to implement any manufacturer specific functionality.

30

MDrivePlus CANopen R020507

Page 38
Image 38
Intelligent Motion Systems DSP-402 manual Bit 4 Voltage Enabled, Bit 5 Quick Stop Active, Bit 7 Warning, Bit 9 Remote