4221 Condor Hardware Installation Procedures

Step 5. Power Off System

Once the board is configured, ensure that the host system and peripherals are turned OFF.

CAUTION

System power and peripheral power must be turned OFF before attempting to install the Condor. Failure to do so may result in severe damage to the board and/or system.

Step 6. Cabling Procedure

The cabling procedure depends on how you wish to configure the system. Your options are summarized in Table 2-19.

Table 2-19. Ethernet Cable Options

 

 

 

 

 

TO IMPLEMENT

CABLING OPTIONS

 

 

 

 

 

 

Ethernet Single Channel AUI/10BaseT Daughter

Front Panel I/O, connect a cable to P3 (RJ45) or P4 (DB15) on

 

 

Card

the front of the Ethernet Single Channel AUI/10BaseT

 

 

 

Daughter Card.

 

 

 

Note: Only one cable or interface type can be used at a time.

 

 

 

 

 

 

Dual 10BaseT Ethernet Daughter Card

Front Panel I/O, connect cables to P3 & P4 (RJ45) on the front

 

 

 

of the Dual Channel 10BaseT Ethernet Daughter Card.

 

 

 

 

 

 

Dual AUI Ethernet Daughter Card

Front Panel I/O, connect cables to P3 & P4 (DB15) on the front

 

 

 

of the Dual Channel AUI Ethernet Daughter Card.

 

 

 

 

 

51