Interquartz IQ750 manual Date and Time SET UP Display, Date Setting

DATE AND TIME SET UP DISPLAY

The best time to set up the Date and Time is during installation, as follows:

Upon installation the display will automatically show step by step prompts to guide you through the Date and Time setup procedure. This procedure can also be used at any time to change the time and date settings.

The following procedure assumes that all steps in the “General Setting Up” have been carried out.

TIMER

FIGURE 1A DATE SETTING

1.If the display is blank, lift the Handset briefly to wake up the telephone and replace the Handset in the cradle

2.For 10 seconds the display will show “20040101” and “DATE-YYYYMMDD” when the unit is first powered up

3.If the display is alive but not showing “20040101” and “DATE-YYYYMMDD”, press STORE, TIMER; the display will return to the “20040101” and “DATE-YYYYMMDD” mode. Proceed to step 4 within the next 10 seconds; repeat step 3 if necessary to re-enter Date/Time setting mode.

4.Enter Year (4 digits), Month (2 digits) and Date (2 digits)

TIMER

FIGURE 1B HOUR MODE SETTING

5.Hour Mode Setting - the display will now show “1-12HR 2-24HR”

6.Press 1 for 12 hour mode or 2 for 24 hour mode display (if 24 hour mode was chosen, please go to step 9)

9