Front Riggings, Installing | Invacare 9000 STANDARD WEIGHT guide

5 FRONT RIGGINGS

5 Front Riggings

WARNING

After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely. Otherwise injury or damage may occur.

5.1Installing/Removing the Swingaway Footrest Assembly

Installing

1.Turn the swingaway footrest assembly to the side (so that the footplate is perpendicular to the wheelchair).

2.Install the hinge plates on the swingaway footrest assembly onto the hinge pins on the wheelchair frame.

3.Push the swingaway footrest assembly towards the inside of the wheelchair until it locks into place.

4.Repeat this procedure for the other footrest assembly.

The footplates will be facing each other when locked in place.

Removing

1.Push the footrest release lever toward rear of chair.

2.Rotate swingaway footrest assembly outward.

3.Lift the swingaway footrest assembly off of the hinge pins.

Footrest Release Lever

Hinge Plates

Hinge Pins

FIGURE 1 Installing/Removing the Swingaway Footrest Assembly

Invacare® Jymni™ Pediatric Series Wheelchair

34

Part No 1100868

Image 34

Invacare 9000 STANDARD WEIGHT user manual Front Riggings, Installing/Removing the Swingaway Footrest Assembly

Contents

Page Invacare Jymni Pediatric Series Wheelchair Contents Arms ANTI-TIPPERS/WHEEL Locks Symbols General Limited Warranty Crossmember OverviewLabel Locations Lower Frame Tube Models with Quick-Release Axles Only On all adjustable Anti-tippersJymni Recliner Models Only Typical Product Parameters 35½ to 39¼ inches 19 or 23 inchesPermanent Aluminum Component Identification Front Caster Safety General Guidelines Operating Information Anti-tippers General Warnings Hand Grips Information for Healthcare Professionals/Assistants Lifting Repair and Service InformationRamps, Slopes, Inclines and Obstacles Seat Positioning Strap Weight LimitationWeight Training Tire Pressure Wheelchair Tie Down Restraints Wheel LocksWheelchair User Stability and Balance Safety/Handling of WheelchairsRecliner Models Only Refer to the procedure that is checked to maintain Forward Reaching, Leaning and Bending Forward or SidewaysBackwards Method 1 Wheelchair With Step Tubes Coping With Everyday ObstaclesTipping Step Tube Stairways Method 2 Wheelchair Without Step Tubes Moving Up Stairs Moving Down Stairs Escalators Transferring To and From Other Seats Unfolding and Folding Wheelchair Unfolding Sling Seat Folding Sling Seat Unfolding/Folding Solid Seat Model Wheelchairs Safety Inspection Checklist Safety Inspection/TroubleshootingInspect/Adjust Initially Inspect/Adjust Weekly Inspect/Adjust Monthly Solutions TroubleshootingInspect/Adjust Periodically Casters Squeaks Suggested Maintenance Procedures Maintenance Maintenance Safety PrecautionsDamage may result Replacing/Repairing Rear Wheel Tire/Tube Replacing/Repairing Caster Tire/Tube Transporting the Invacare Jymni Front Riggings InstallingInstalling/Removing the Swingaway Footrest Assembly Removing J932A-14 Swingaway Footrest Height AdjustmentUpper Footrest Support Bolt Locknut Lower Footrest Assembly J932A and J933A JA932A-14 Elevating Legrest J934A-14 onlyJA932A J934A-14 Step Installing/Removing Elevating Legrest AssemblySteps 2 Adjusting Height Lowering Legrest AssemblyAdjusting Calfpad Detail a Adjust armrest to one of five positions Adjusting Armrest HeightArms Using Swing-Back Arms Armrest Release Lever Rear Arm Socket Replacing Armrests Removing or Replacing ArmrestRemoving Armrests Post Replacing Clothing Guards Fixed Height Arms Only Guard to the armrest assemblyMounting Screws Clothing Guard Armrest Pad Assembly Converting Between Space Saver and Conventional Arms Space Saver Arm Position Conventional Arm Position Seat and Back Replacing Seat Upholstery Washer Mounting Screws Back Upholstery Back Cane Replacing Back UpholsteryBack Cane Wheelchair Frame Locknuts Mounting Screws Adjusting Back Height Cane to the wheelchair frame are not shown for clarity Adjusting Seat Width and Depth Rear Wheels Removing/Installing Rear WheelsPermanent Axles Inside Wheelchair Quick-Release AxlesDetail a Detent balls and detent pin Outside Wheelchair Adjusting the Quick-Release Axle Wheelchair Frame Locknut Locking Pins Replacing Rear Wheel Handrim Replacing Rear Wheel Handrim Installing/Replacing Front Casters and Forks Front Casters Replacing/Repairing Front Caster Tire/Tube Adjusting Front Caster Mounting Installing/Adjusting Anti-tippers Anti-tippers/Wheel Locks Anti-Tipper Release Buttons Rear Frame Tubing Installing Anti-Tippers1101959 1058752 Anti-Tipper Length Adjusting Anti-Tippers Inches Pull-To-Lock Using Patient Operated Wheel LocksPush-To-Lock Pull wheel lock handle toward the tire to engage wheel lock Wheel Lock Wheel Lock Shoe Rear Wheel Adjusting Patient-Operated Wheel LocksAdjusting Patient-Operated Wheel Locks Inch 3/16-inch pneumatic tires Wheel Lock Shoe Tire Recliner Operating Recliner Upright Position Reclined Position Installing/Removing Headrest Extension Replacing Headrest Pillow Back Upholstery Replacing Headrest/Back Upholstery Headrest UpholsteryKnob Back Upholstery Removing From Stored Position Adjusting Headrest/Back Upholstery TensionStoring/Replacing Spreader Bar Storing Spreader Bar Headrest Upholstery Spreader Bar Back Placing In Stored Position Adjusting the Seat Width and DepthReplacing Spreader Bar Installing Telescoping I.V. Rod/O2 Holders Options Tie Wrap CleaningDetail a I.V. Rod/O Detail B O 2 holder Holder Step Tube Locknut Installing the 1-inch Forward Rear Wheel Positioner Wheel Positioner Repeat Steps 1-3 for the opposite stroller handle Installing/Adjusting Stroller Handles RemovingHeight Adjustment Repeat Steps 1 3 for the opposite stroller handle Installing/Removing the Solid Back Insert Installing/Removing the Solid Seat Insert InstallingInstalling the Wheel Lock Extension Handle Invacare Jymni Pediatric Series Wheelchair Invacare Jymni Pediatric Series Wheelchair Canada One Invacare Way