5 FRONT RIGGINGS
Part No 1100868 35 Invacare® Jymni™ Pediatric Series Wheelchair

5.2 Swingaway Footrest Height Adjustment

1. Remove the swingaway footrest assembly. Refer to Installing/Removing
the Swingaway Footrest Assembly on page34.
2. Remove impact guards and/or calf strap, if necessary.
3. Perform one of the following:
A. Wheelchairs equipped with 80° swingaway footrest (Model
J923A-14):
Loosen, but do not remove the bolt and lock nut that secure
the lower footrest assembly to the upper footrest support.
Reposition the lower footrest assembly to the desired
height.
Securely tighten the bolt and locknut.
B. Wheelchairs equipped with 70° swingaway footrest (Model
Number J932A) OR 90° swingaway footrest (Model J933A):
Remove the bolt, locknut and four washers that secure the
lower footrest assembly to the upper footrest support.
Align the mounting hole of the lowe r footrest assembly with
the desired height adjustment hole in the lower footrest
support.
Reinstall the bolt through the desired height adjustment hole
in the lower footrest assembly and through the mounting
hole in the lower footrest support. Securely tighten with the
locknut and four washers.
4. Repeat this procedure for the other footrest, if necessary.
5. Replace impact guards and/or calf strap, if necessary.
6. Reinstall the swingaway footrest assembly. Refer to Installing/Removing
the Swingaway Footrest Assembly on page34. FIGURE2 Swingaway Footrest Height Adjustment
Lay the assembly on a flat surface to simplify this
procedure.
Upper Footrest Support
Lower Footrest
Assembly
Bolt and
Locknut

J932A-14

J932A and J933A

Upper Footrest Support
Lower Footrest
Assembly
Locknut
Washers
Bolt