10 ANTI-TIPPERS/WHEEL LOCKS
Part No 1100868 55 Invacare® Jymni™ Pediatric Series Wheelchair
Installing Anti-Tippers
1. Depress the release buttons and insert the anti-tippers with the
anti-tipper wheels pointing toward the ground/floor into the
wheelchair frame tubing as shown in FIGURE1.
2. Measure the distance between the bottom of the anti-tipper wheels
and the ground/floor.
3. If the distance between the bottom of anti-tipper wheels and the
ground/floor is not 1½ to 2-inches, adjust anti-tippers. Refer to
Adjusting Anti-Tippers on page56.
4. If necessary, reverse STEPS 1-2 to remove the anti-tippers.
FIGURE1 Installing Anti-Tippers
To ensure the correct model anti-tipper is used refer to the Anti-tipper Identification Chart below. Measurements for anti-tippers are
approximate and are taken with extension tube in top hole position Detail “A”.
REAR WHEEL SIZE ANTI-TIPPER LENGTH ANTI-TIPPER PART NUMBER
20 inch 9 inches 1101959
22 inch 9-5/8 inches 1058752
A 1½ to 2-inch clearance between the bottom of the
anti-tipper wheels and the ground/floor MUST be
maintained at all times.
Anti-Tipper
Wheels
Anti-Tipper
Release Buttons
Rear Frame
Tubing
Anti-Rattle
Anti-Tipper
Length
Anti-Tippers Top Position
Detail “A”